Instructions for setting up the

One For All URC3220

3 Component Universal Remote Control

1) Find the Code that matches the jumper setting in the remote receiver. Most of the time it will be the first line (JMP, JMP).

Use the following table if controlling a tape deck

JMP1

JMP2

Code

Device Type

JMP

JMP

----

Beta VCR

JMP

OPEN

----

8mm VCR

OPEN

JMP

0032 or 1232

VHS VCR

OPEN

OPEN

----

LDP

Default jumper setting is JMP1 and JMP2 = JMP.

Since the URC3220 remote does not support the default setting the receiver will need to be opened and the jumpers adjusted to JMP1=OPEN and JMP2=JMP

Use the following table if controlling a disc player or recorder

JMP1

JMP2

Code

JMP

JMP

?

JMP

OPEN

?

OPEN

JMP

?

OPEN

OPEN

?

Default jumper setting is JMP1 and JMP2 = JMP

2) Press and release the DVD/VCR button.

3) On the One For All remote press and hold the SET button until the red light blinks twice, then release.

4) Enter the four digit Component Code on the remotes number pad. If done correctly the red light should blink twice on the last digit. If done incorrectly the red light will flash only once on the last digit.

The DVD/VCR preset should now be set.

The full instruction manual for this remote located here --> One For All URC3220 Manual

The complete Code list for this remote is located here --> One For All URC3220 Codes