Revox A77 Wireless Remote Adapter Instructions
Installation: Turn off the power to the tape deck. Plug the remote adapter into the remote connector located on the top or back of the tape deck. Now power can be turned back on. The light on the front of the remote adapter should be on.
The remote adapter controls the standard 5 transport functions: Play, Stop, F.F., Rewind and Record using any universal remote programmed for the matching Sony VCR code.
The remote adapter can be programmed to respond to various Sony VCR codes. To select between them there are two jumpers inside the unit. Remove the two screws on the bottom of the unit and remove the top cover.
Located near the front window is a jumper block. These jumpers configure what type of Sony VCR codes the unit will respond to. See the table below for a list of jumper settings.
JMP1
|
JMP2 |
Device Code |
RCA Remote |
JMP
|
JMP |
Beta VCR |
VCR-119 * |
JMP
|
OPEN
|
8mm VCR
|
VCR-098 |
OPEN
|
JMP
|
VHS VCR
|
VCR-099 |
OPEN
|
OPEN |
LDP |
---- |
* = Default jumper selection
Configuring the RCA Universal Remote
To program the RCA remote press and hold the Code
Search button until the red light comes on. Release the Code Search button
and momentarily press the VCR button then enter the 3 digit code from the
table above (default is 119). The red light should blink after each keypress
and go out after the last digit is entered. Press the VCR button and press
one of the transport control buttons (PLAY, STOP, FF, REW, REC or PAUSE).
The light on the front of the remote adapter should blink off momentarily.
If the light does not blink off try reprogramming the remote or checking the
state of the jumper inside the unit. On the RCA remotes the REC button needs
to be pressed twice to activate record.
For instructions on configuring other remotes go to this page and select from the list of tested remotes. Click Here