Plugs into the 15-pin Parallel Remote connector on the back of your unit.

Ready to ship
I sell this on eBay for $60 or buy direct for $55. Shipping is $10 within the US or $23 outside.

Contact me at scott@revoxremotes.com

This adapter will control the following tape transport controls: Play, Pause, Previous Track, Next Track, Locate and Start Review.

Includes a universal remote which includes batteries and is preprogrammed to work with the remote receiver. A pair of jumpers inside the remote adapter allows you to select between four different remote codes in case you have a conflict with an existing DVD player or if you want to have multiple remote adapters in the same room.

Installation:
Turn off the power to the CD player. Plug the remote adapter into the remote connector on the back. Now power can be turned back on. The light on the front of the remote adapter should be on.

The remote adapter controls the following eight functions (if supported): Play, Pause, Next, Previous, F.F., Rewind, Locate and Review. Since there is no button for Locate it is activated by pressing #1 on the key pad. Review is activated by pressing #2. Previous and Next are controlled by the two buttons above the Rewind and F.F. buttons or by the left and right arrow buttons next to the Select button.

Instructions PDF for Studer D732

* = Default jumper position

Configuring the DirecTV remote
To program the remote first slide the switch at the top to AV1 or AV2. Press and hold the MUTE and SELECT buttons until the green light at the top blinks twice then release. Using the number keypad enter the 5 digit device code from the table above. If done correctly the green light will blink twice after the last digit is entered. The full manual for the remote can be found here: DirecTV Remote

Remote adapters are also available for Aiwa, Akai, Ampex, Crown, Denon, Nakamichi, Otari, Pioneer, Revox, Sony, Studer, Tandberg, Tascam, Teac and Technics decks.